Fleck 5600 Series

Fleck 5600 Stainless Steel 1" Yoke

Main gear & shaft for the Fleck 5600 control head (Fleck part# 13170). This is typically the only gear that may break or wear out. Product Features Idler Gear   Fleck Part# 13017 This is a genuine Fleck part and is part# 13017 Product...

60125-15 Chloramine Resistant Top Seals And Spacers Kit for Fleck 5600, 9000, and 9100 Valves.*NOT for Hot Water (that is PN 60125-05)The material of the seals has three times the Chloramine resistance of the previous silicone material used.The new seals...

Clip for use with Fleck turbine meters to connect to control head For turbine meters only. Part 19569

Replacement piston assembly for the Fleck 5600 softener valve. The low water piston shortens the backwash time to 7 minutes, rather than the 10 minutes that is standard with the normal piston. These wear out over time and can cause your control head to...

Rebuild kit for the Fleck 5600SXT filter valve. Kit includes piston assembly (Fleck part# 60102-71) and seal and spacer kit (Fleck part# 60125). For the Fleck 5600SXT digital softener valve rebuild kit, see FP-56SXT-RBKS. Product Features Fleck...

Fleck 5600 Filter Timer Valve with "L"-style bracket For filters up to 10" diameter DLFC is NOT included Flow rates: Peak: 26 GPM (25 psi drop) Continuous: 20 GPM (15 psi drop) Valve Flow Coefficient (Cv): 5 GPM (1 psi...

PISTON ROD only, Fleck 5600, PN 13001.

End Plug Fleck 5600 ( white standard ) 9000 PN 13446This part is included in the complete Piston Assembly, PN 60102-00. We typically recommend replacing the entire assembly. As shown in the 2nd photo, the older end plugs were more round at the top,...

This kit includes 10ft of 1/2" ID clear drain line (5/8" OD), stainless steel hose clamp, and a roll of teflon tape. The stainless steel hose clamp is used to secure the drain line on the barbed drain fitting on the Fleck control head. Teflon tape is...

Replacement cable for Fleck 5600 valve, has the ends that you just push firmly into the meter and control head. 6.25" long

Fleck 5600 L-Back Downflow Metered Softener Control Valve, Paddle Wheel Meter, 120V/60Hz, U.S. Power Cord, Softener Bypass Piston, #1 Injector, 0.50 GPM BLFC, L-Style Housing, Silver/Blue Label.

Curved spring washer used behind the Timer Mounting Plate on Fleck 5600 Valves made before 1998. part #A13299

Fleck 5600 Design Cover Black "L"

Replacement piston assembly for the Fleck 5600 softener valve. The low water piston shortens the backwash time to 7 minutes, rather than the 10 minutes that is standard with the normal piston. These wear out over time and can cause your control head to...